Network settings
System
The following table provides detailed instructions on each configuration setting:
Configuration Parameter Name | Description |
---|---|
Server IP Address | IPv4 address of the server. This setting is used to define the proper network interface to use by various Verba Recording System components on the network. This IP address should be accessible by other components of the system in the network. If this setting is not configured, certain services may not start at all. |
Server S-NAT/Public IPv4 Address | The IPv4 address of the server which is visible from outside network. This is required in several cases when the recorder has to advertise its external IP address also, so the remote party can connect. |
Server IPv6 Address | IPv6 address of the server. If empty, then the IPv4 address will be used. This setting is used to define the proper network interface to use by various Verba Recording System components on the network. This IP address should be accessible by other components of the system in the network. If this setting is not configured, certain services may not start at all. |
Server S-NAT/Public IPv6 Address | The IPv6 address of the server which is visible from outside network. If empty, then the corresponding IPv4 setting will be used. This is required in several cases when the recorder has to advertise its external IP address also, so the remote party can connect. |
Multi-Tenant Mode | If set to Yes, then the server will be in Multi-Tenant mode. For more information see: Multitenancy |
Recording
The following table provides detailed instructions on each configuration setting:
Configuration Parameter Name | Description |
---|---|
Telephony Gateway IP Addresses | IP addresses of telephony gateways. The recorder services can determine the call directions based on this setting, if the recording service specific Internal Domain, Number Pattern setting is not set. |