/
Configuring gateway preferred forking

Configuring gateway preferred forking

Owned by Kiss, Mate
Feb 23, 2024

Gateway requirements

  • Supports both Voice gateways and Unified Border Elements (CUBE) as long as they interface with Unified CM using SIP and the Router platform supports the UC Services Interface (not supported for H323 or MGCP based calls)
  • The word gateway is used interchangeably to refer to both Voice gateways and CUBE devices.
  • The Gateway has to be directly connected to the Unified CM using a SIP trunk. No support for SIP Proxy servers
  • ISR-G2 Gateways (29XX, 39XX Series) running release 15.3(3)M or later are supported. 15.3(3)M was released on CCO in July / 2013
  • ASR-100X Gateways running release XE 3.10 or later are supported. XE 3.10 was released on CCO in July / 2013
  • VG224 is not currently supported

Configuring the Cisco UCM

You need to mark the Gateway - CUCM trunk as recording enabled:

Follow the Configuring Cisco UCM for central recording guide to create them.

Configuring the Cisco gateway

Create xmf provider using the following commands to each CUCM subscriber node: (replace the example ip address to your Cisco UCM ip address(es))

//Configure HTTP connectivity for XMF API
Device(config)# http client connection idle timeout 600
Device(config)# ip http server
Device(config)# no ip http secure-server
Device(config)# ip http timeout-policy idle 600 life 86400 requests 86400
//Replace source-interface with GW's interface facing CUCM network
Device(config)# ip http client source-interface GigabitEthernet0/0/0
Device(config)# http client connection persistent
//Configure WSAPI XMF
Device(config)# uc wsapi
Device(config-uc-wsapi)# message-exchange max-failures 2
//Replace source-address with IP with GW's IP
Device(config-uc-wsapi)# source-address 10.30.110.2
Device(config-uc-wsapi)# probing interval negative 20
Device(config-uc-wsapi)# probing max-failures 5
Device(config-uc-wsapi)# provider xmf
Device(config-uc-wsapi)# no shutdown
//Replace URL with CUCM address
Device(config-uc-wsapi)# remote-url 1 http://192.168.111.111:8090/ucm_xmf
Device(config-uc-wsapi)# remote-url 2 http://192.168.111.112:8090/ucm_xmf
Device(config-uc-wsapi)# end
Device# show wsapi registration all

Provider XCC
=====================================================

Provider XMF
=====================================================
registration index: 1
id: 32EC5A98:XMF:Unified CM 10.5.0.99833-3:4
appUrl:http://192.168.111.111:8090/ucm_xmf
appName: Unified CM 10.5.0.99833-3
provUrl: http://192.168.111.111:8090/xmf
prober state: STEADY
connEventsFilter: CREATED|DISCONNECTED
mediaEventsFilter:


Related content